First time login Edge After you login to Edge with the Edge Management interface you will see the following screen. The Edge provided to you...
How to connect the management interface to Edge The Edge Management Interface is a web-based tool that can be used to connect to The Edge. In order to...
How to configure charge points to connect to Edge Edge will automatically configure the OCPP settings of supported chargepoints to allow for optimal load balancing. The only part you...
How to Install Edge – Physical Installation This Installation Guide will explain a Edge installation using a simple example. For this simple Edge installation, we will consider...
How to Install Edge – Energy Meter Installation Let’s use the previous example as a start for this energymeter installation example. But now there is also a small...
How to specify user friendly name When a charge point is added It can be recognized by it’s communication ID. This ID can be confusing to...
How To Configure an Energy Meter Energy meters are optional in Edge (although highly recommended). They are required when there is an uncontrollable load in the...
How To Configure the Grid: Simple Example Because of the many different use cases of load balancing supported by Edge, the configuration can be a bit confusing....
How To Configure the Grid: Advanced Example In this next example we will repeat most of the steps taken in the first example. However, this example will...
How To Connect an Ecotap master-slave Grid to Edge Edge has support for the legacy LMS/Ecotap protocol. As a result, Ecotap master slave configurations can now be connected using...
How to configure Time of Use Edge support variable grid limits, we call such schedule-based limit Time of use (ToU). A ToU schedule can be assigned to...
Charge Card Management & Charge Card Priority Edge requests all authentication information from EVC-net. After that it saves the information about all charge cards that are used...
Edge Demo Mode In Demo mode Edge will simulate the charging stations so you can test Edge without having to deal with real...
How to configure Solar Charging The Edge load balancer controls EV charging rates to make sure that the grid limits are not exceeded. There are...
Priority charging Priority charging and delayed charging is only relevant when there is not enough current to have all chargepoints charge at...
How to use a Modbus TCP gateway for Energymeters Edge supports Modbus TCP, which is useful in situations where installing a modbus cable to the energy meter is not...
Connecting EVBox to Edge (non-OCPP) Connecting an EVBox that has no Ethernet connection to Edge happens in 2 steps. After the connection is done the...